In the course of its service, the wooden floor has to be regularly subjected to enormous loads. If you do not take care of its protection in time, even the most expensive and durable parquet will inevitably lose its attractiveness, will be covered with a network of cracks and scratches, will get “unhealthy” dull appearance. In this article we discuss parquet polishing, but if you need concrete polishing, just visit Southside Concrete Polishing.
The procedure, called polishing, is designed just to avoid such changes and to prevent the noble covering prematurely “fall into despair.
How often is a parquet polished
Hotels, offices and other areas with high passability are polished every month. For home conditions, sessions are reduced to one or two per year: this is enough to slow down the wear and tear on the wood and prevent the top layer from being worn down.
Most often, a varnish or oil-wax mixture is used to finish parquet panels. Although the lacquer is considered to be the strongest coating and the oil easily reaches the pores of the wood, its protective properties are not sufficient, if only because the joints between the strips remain susceptible to moisture, dust and dirt particles. Polyrolys penetrate all hard-to-reach corners of the parquet, filling gaps in care, highlighting the juiciness of colors and repeatedly extending the life of the floor.
How to pick up a floor polish
Polishing agents (often referred to as polishes) can be produced as liquid concentrate or spray, all of which are absolutely safe for paintwork and do not form surface stains. These compositions are based on natural wax and a set of polymers: they form an invisible film that protects the wood from mechanical injury, overwetting and destructive UV.
There are 2 basic types of polishes:
The soluble ones are oriented towards the treatment of the lacquered floor and are diluted with water before application. The parquet will turn out to be shiny, but it will not slide if the dosage is precisely observed. Water-based polishes are much cheaper, but the effect of using them will not last long.
Wax polishes are suitable for oil-impregnated floors. They appear in the form of sprays or thin mastic, it is very important to make sure that there is no spillage on the parquet when distributing them. The main disadvantage is the inflated cost, but on the other hand, such polishes guarantee the longest possible result. Also read the wax for your parquet.
In terms of appearance, the compositions are divided into the following categories:
Matt polishes clean the floor well and increase its resistance to wear. Suitable for any lacquered rock, after application a matt protective shell is fixed to the surface.
Glossy polishes are sprayed out, which saves time and effort. They do not need pre-dilution and do not cause any harm if applied too thick. The coating emits a radiant glow, and shoe prints are not usually trapped on it. There are also semi-glossy varieties with a muted shine.
Polishing process
First of all, we have to learn one indisputable rule: the polish must lie on a perfectly clean surface. The parquet should be thoroughly washed with a special product (e.g. “Bona Cleaner” or “Tarkett Cleaner”), then washed with plenty of clean water and dried to the last drop of moisture.
The composition can be distributed using any handy product – a special mop, soft brush or a wet microfibre cloth. The first layer of polish is applied along the wood fibres, after it dries (it lasts from thirty minutes to two hours) the parquet is rubbed with an electric pollotter or a noncoarse rag. Then the floor is covered with a fresh layer of polish: now it is applied perpendicular to the previous layer. Step by step move towards the door, otherwise by the end of the work you will be isolated from the world – it is strictly forbidden to walk on the treated floor for half an hour. If the impregnation is uneven, the procedure can be repeated; in total, the floor will dry for about twelve hours.
Polished parquet does not require a sensitive attitude. Periodically, dust is collected from it, during wet cleaning the rag must be pressed hard. It is recommended to renew the polish layer twice or three times a year.